A nail pop is something that happens gradually over time. It is not cause for major concern but it can be unsightly especially when the nail pop is located in an area that you would frequently notice. There are different causes for nail pops. The wood behind the wall might move over time and as this happens, the nail is pushed outward, causing the nail to pop. In some cases, the frame is uneven which causes the nail to pop out as the drywall pushes against it to retain its flat shape. How hard is it to mend a nail pop? Luckily, it’s not hard to fix nail pops. You could do the fixup on your own. Or, you could hire a handyman to patch it up for you. On average, it would only take at least an hour to fix a few nail pops. The speed will depend on the mud used and how fast the handyman does the repair. For any kind of home repairs, it is best to hire handyman services since you don’t need to go through the hassle of doing the repairs yourself.
How a handyman would fix a nail pop
Find the framing
First off, you will need to find the frame behind the drywall. This step is important because you will need to secure the drywall later on using nails or screws. You can easily do so by knocking on the area around the nail pop. When you hear a hollow sound, the frame is not behind that area. However, when you hear a sharper, fuller sound when you tap, then the frame is behind that area. You can then proceed to the next step. If you are not too sure about what you are doing, hire handyman services Conway, SC instead.
Secure the drywall
The following procedure is securing the drywall. You can do this by driving a screw-on top and at the bottom of the nail pop. This will expose the nail or screw in the middle. You can then remove the nail or screw to prepare for the patch-up.
Depress the nail
The next thing that needs to be done is creating a hole. Widen the hole where the nail or screw was. This is to make enough room for the mud later in the next step. Once the hole has been widened, depress the nail or screw just below the level of the drywall.
Seal the area
 
You then need to prepare the mud mixture to fill in the hole. The screws that were driven to secure the drywall also need to be a little under the drywall. They should not sit flush. This is to allow for a smooth finish afterward.
Sand the area
Once the area has been filled with mud, let it dry for about 30 minutes. Once dry, sand the area lightly until it is all flush.
Do the final touchups
After the sanding, paint the area. If done correctly, the affected area should be good as new. If you find any home repairs difficult, be sure to hire a handyman. An expert like Handyman Conway can help you with any kind of home repair.
If you need help with drywall repair and other tasks, don’t hesitate to call Handyman Conway. You may reach us at (843) 353-6154.
Handyman Conway
Conway, SC 29526
843-353-6154
info@handymanconway.com
http://handymanconway.com/
Areas Served: Conway, Aynor, Carolina Forest, Myrtle Beach, North Myrtle Beach